Avidyne Entegra EXP5000 Instructions d'exploitation télécharger pdf (Page 36)

Setting Up the HSI

Entegra EXP5000 PFD -30- 600-00157-000 Rev. 06

3.4 Setting Up the HSI

The Envision EXP5000 can integrate with single or dual GNS 400/

500-series GPS or GPS/VHF navigator systems. When your

EXP5000 PFD is installed, it is configured for the number and type of

navigator systems on board.

Use the Nav button (Primary Nav) to select the navigator source for

the green single-line CDI and the moving map data. The active flight

plan from the selected navigator unit drives the moving map on the

HSI and will display up to 15 waypoints, including the curved

approach path and holding pattern segments.

GPS 1 is also the primary source for ground-speed readout and a

required element for the wind vector calculation and display. If GPS 1

is unavailable, ground speed and wind vector data are derived from

GPS 2. If the Nav source is selected to a VOR or localizer source, the

Note: Garmin 400W/500W-Series GPS or GPS/VHF navigator systems are

capable of flying a parallel offset track. Since the 400W/500W navigators do

not provide the PFD with information to depict the parallel offset flight plan

correctly, the PFD does the following when the 400W/500W is navigating to

a parallel offset track:

● The offset flight plan is not depicted.

● The original non-offset flight plan is depicted on the HSI with the

active leg shown in white instead of magenta.

● The To Waypoint identifier is removed from the Nav/Bearing/

Aux datablock.

● The waypoint identifier in the Primary Nav datablock is

removed.

Note: The Garmin 430W is capable of redrawing holding patterns based on

groundspeed. However, the 400W/500W navigators do not always transmit

the correct information to external devices to allow them to draw holding

patterns correctly. In these situations, the depiction of the holding pattern

on the PFD will not match that of the 400/500W. If this occurs, correct

guidance is still provided on the CDI/HDI and also to the autopilot while in

GPSS mode.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 89 90

Pas de commentaire

Avidyne Entegra EXP5000 Instructions d'exploitation Page 36