Avidyne Entegra EXP5000 Instructions d'exploitation télécharger pdf (Page 22)

EXP5000 Buttons and Knobs

Entegra EXP5000 PFD -16- 600-00157-000 Rev. 06

VHF navigator system, the available sources are: GPS 1, VLOC

1, GPS 2, and VLOC 2.

2) Bearing (Secondary Navigation)—Controls the source for the

Bearing Pointer and adjacent data block. In a dual GPS/VHF

navigator system, the available sources are: GPS 1, VLOC 1,

GPS 2, VLOC 2, ADF (if available), and OFF.

3) Depending on your aircraft configuration, this button will display

one of the following:

■ Indicated Airspeed Bug (IAS Bug)—The IAS button

displays the IAS Bug, except when the aircraft is configured

with an S-TEC 55X Autopilot and a radar altimeter.

For S-TEC 1500 and 55X Autopilots, the IAS Bug is for

reference only and is never coupled to the autopilot.

For the S-TEC IntelliFlight 2100 Autopilot:

◆ If the PFD is controlling the IAS bug, the button displays.

◆ If the autopilot is controlling the IAS bug, the IAS Bug and

speed display as a label and cannot be set from the PFD.

■ Decision Height Alert (DH Alert)—If your aircraft is

equipped with an S-TEC 55X Autopilot and a radar altimeter,

the DH Alert button displays. For more information about the

DH button and the radar altimeter, see Right Buttons and

Knob, on page 19.

4) HSI Moving Map Range and View Button (Range/View)—

When selected, Range/View allows the left knob to control the

HSI’s moving map range and view:

■ Pushing the knob—Cycles the HSI through the HSI views

(360° with map; 360° without map, 120° with map; 120°

without map).

■ Rotating the knob—Changes the HSI moving map range

when the map is available.

For more information about the HSI Map, see Section

3.4, "Setting Up the HSI" on page 30.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 89 90

Pas de commentaire

Avidyne Entegra EXP5000 Instructions d'exploitation Page 22