Avidyne Entegra EXP5000 Instructions d'exploitation télécharger pdf (Page 21)

EXP5000 System Overview

600-00157-000 Rev. 06 -15- Entegra EXP5000 PFD

2.4 EXP5000 Buttons and Knobs

Left Buttons and Knob

The left-hand buttons and knob on the Envision EXP5000 allow you

to set the navigation configuration and course. The left button

configuration is determined by your aircraft’s autopilot and whether a

radar altimeter is installed. Additionally, for IntelliFlight 2100

autopilots only, the IAS button becomes unavailable when the

autopilot is controlling the aircraft, as shown in Figure 5. For more

information, see IntelliFlight 2100 Vertical Modes, on page 44.

The Nav (Primary Navigation) button is enabled by default (the

enabled button has a green rim). To enable a different left-hand

button, press it. Once enabled, you can continue to press the button

to change the setting.

The state of each navigation button is displayed in the adjacent data

block, as shown in Figure 5. For information about the data blocks,

see Nav and Bearing Data Blocks—The Nav data block content

varies depending on the source, as follows:, on page 18.

Figure 5. Left Knob and Button Configurations

1) Nav (Primary Navigation)—Controls the source for the Course

Deviation Indicator (CDI) and adjacent data block. In a dual GPS/

Note: The Nav button is re-enabled ten seconds after you last push or

rotate the Bearing and Range/View button. Avidyne suggests that you

enable the desired button just before you change the knob.

All AP without RadAlt

2100, AP

Control

55X with

RadAlt

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 89 90

Pas de commentaire

Avidyne Entegra EXP5000 Instructions d'exploitation Page 21